Not At Headup
The head is not at headup. Moving the carriage assembly is not allowed unless the head is at
headup. Cycle the head to the headup position with the Head Timing Menu function go to headup.
Outside of Hoop
The Trim Menu option, Trim Immediate, or the Change Thd option in the Splicing Menu, has been
selected when the needle position is outside of the currently selected hoop size. Select a different
hoop size or move the beam so the needle position is within the hoop limits.
Picker Limit
This message means that the drive circuit of the picker trimmer solenoid has detected excess power.
This is caused by a malfunction of the picker trimmer solenoid or electronics. Turn the power OFF
then ON to recover. If this error occurs more than once during a design, call your representative for
assistance.
PR Job Error
Trying to do a power fail recovery but the design was finished.
Pressure High
This means the sensor detects air pressure above a 90 to-100 psi range. Adjust the air compressor
regulator if necessary. If the air pressure
is
below 100 psi, the sensor can be disabled in the Splicing
Menu. Press [START] to continue.
Pressure Low
This means the sensor detects air pressure below a 65 to 75 psi range. Adjust the air compressor
regulator if necessary. If the air pressure
is
above 70 psi, the sensor can be disabled in the Splicing
Menu. Press [START] to continue.
Rack Limit???
If the X or Y motion is not within the embroidery field limits when the machine is running, the
peripheral will stop and give this error. If performing frame forward or frame back functions, this
error message will be displayed when you reach the limits of rack movement. If not in the Frame
Menu, then go to the Home Menu and check the Hoop Limits submenu. You may be using a hoop
size that is too small for the design, or the design start point is not positioned correctly. Try
selecting a larger hoop size, or moving the design start point so the whole design fits into the
hoop, then start over.
Reload
An error was found when the computer was loading a design while running in Auto Send. Delete
the design and reload it from the computer. Frequent occurrences indicate a system memory
problem, or a bad link in the network. Check the terminator cable to be sure it is plugged in and
not missing. If this does not fix the problem call your service representative for help.
Reload
B - 5
110265-01, Rev. A
B. Error Messages
Summary of Contents for Advantage 18
