Operating Manual for Euroklav
®
23V-S
Page 15
Program status
Display message
6.
1st drying phase
(Flow drying)
After pressure release the drying phase
begins.
Throughout the drying phases of the
program can be ended without an error
report, since the sterilization itself has been
completed.
However, with the exception of the "Quick
Program" you should normally wait until the
drying is completed..
7.
2nd drying phase
(Vacuum drying)
The flow drying is then followed by a final
pulsed vacuum drying phase.
Throughout the drying phases the program
can be ended without an error report, since
the sterilization itself has been completed.
However, with the exception of the "Quick
Program" you should normally wait until the
drying is completed..
8.
Program end
After ventilation of the chamber the
program is completed.
If a printer is attached and print-out "yes" is
selected, the record will be printed-out
immediately.
After the door has automatically unlocked
the door can be opened to remove the
sterilized objects.
Program Start-Stop
V a c u u m - d r y i n g
s i n . 2 ' - 0 . 1 2 b a r 6 0 ° C
Program Start-Stop
I m m e d i a t e r e m o v a l
P r e s s S T O P
Program Start-Stop
C u r r e n t d r y i n g
s i n . 1 ' 0 . 9 b a r 8 5 ° C
Programm Start-Stop
I m m e d i a t e r e m o v a l
P r e s s S T O P
Program Start-Stop
O p e n d o o r
p l e a s e
Program Start-Stop
Q u i c k P r o g r a m
r u n s u c c e s f u l l y
Program Start-Stop
P l e a s e w a i t
D o o r u n l o c k i n g
