Installation
The ETN24-PM-HP-SUPER is designed for wall mounting in the room to be controlled. It should be
located where the occupant can easily read the LCD display and use the controls. If the built in
temperature sensor is being used to measure room temperature, the module should be placed where the
temperature is representative of the general room conditions. Cold or warm air draughts; radiant heat and
direct sunlight should be avoided.
General points to follow:
- Disconnect power to the main board before installing the unit.
- The standard height to install this unit is 1.5 meter (5 feet) from the floor.
Installation procedure:
A.
Separate the front panel from back panel by pressing the tongue located in the top of the unit and
pull the back panel out.
B.
Line the back panel up against the wall or flat surface. Install three screws as required.
C.
Make electrical connections as shown on enclosed electrical wiring diagram.
D.
Install the cove to the back panel; first the two tabs on the bottom and then the top tongue. Push
until tight against the wall.
Tel: +972-3-9626462
Fax: +972-3-9626620
support@meitavtec.com
ETN24-PM-HP-SUPER-BL
Owner’s manual & Technician Settings
Pg. 3
Wiring
OP CL
COM
0
T Y B/O G1 G2 C R
Open
Close
Common
Heat
floating
3-Wire
(3A)
Exter
nal sensor (op
tio
n)
Compressor (
0.5A
)
Low (2S Con
fig. only)
Hig
h
Main
sup
ply
24VAC
Notes:
A. Fan
speeds
In 1 speed configuration (DIP switch
selectable), use ‘G2’ (High speed)
output only. ‘G1’ (Low speed) is not
in use.
B. Heating
stages
1
st
stage heat – Floating 3-Wire
(works without fan)
2
nd
stage heat – Compressor w/wo
heat pump (works with fan).
Important – Do not connect
electrical heater on 1
st
stage heat !
Fan
(0.5A)
Heat pump (0.5A)
