34
After setting up the communication port of the main module, the user can open the MTC wizard Settings
by selecting the tool (T) -> thermostat (M) in the menu bar. The interface is shown below.
Figure 4-1 MTC wizard Settings
Configuration module
The software default system is configured with a station number of 1 MTC thermostat. In actual use, the
user should configure the module according to the actual configuration of MTC.
1. When a single MTC is configured on the system.
At this point, the user only needs to modify the module type. The specific operation steps are as follows.
(1) in the
MTC
wizard setup interface (see figure 4-1), right-click site 1 of the structure tree on the left of
the interface.
(2) in the pop-up shortcut menu, select the
modification information
and enter the following interface.
Figure 4-2 modify module parameters
2. When the system is configured with multiple MTC thermostats.
At this point, the user needs to configure the module type and station number. The specific operation
steps are as follows.
(1) Perform the configuration operation "when the system is configured with a single MTC" and modify
