Controlling and monitoring in running operation
36
The situation is different if, for at least one power module, the pulse mode for fault
location (see page 42) has been activated. In this case, depending on the setting, either
individual pulses can be triggered with the button or the automatic pulse mode can be
started/stopped. However, no switching operations are performed on the power modules
that are not in pulsed mode.
The height of the respective surge current is signalled by the LED bar
. Here, the
following scaling applies:
1 LED
>= 5 A
2 LEDs
>= 150 A
3 LEDs
>= 500 A
4 LEDs
>= 1000 A
5 LEDs
>= 3000 A
After the desired switching operations have been carried out and the remote control is
no longer required, it should be switched off with the button
for a few seconds.
