User interface
20
3.1.2
Access through a web browser
The supply module provides various network interfaces, through which users can
connect to the device and access the user interface.
In general, the user interface can be accessed from any internet-connected device (PC,
smartphone or tablet) that has a JavaScript-capable web browser.
The following table provides an overview of the advantages/limitations of each network
interface and the requirements and steps needed to obtain access:
GSM connection
WLAN connection
LAN connection
When is the use of this
network interface
recommended?
Complete remote control over the
internet, including notifications
(see page 49)
Wireless access in the
vicinity (for example, for
configuration after
installation)
Preliminary configuration in the
office
Which requirements
need to be fulfilled?
The activated supply module must
be equipped with a suitable SIM
card and accessible via the
internet (see page 51)
The smartphone / tablet
may be up to 15 m from the
activated supply module
The activated supply module
must be connected via the
Ethernet port
with a
network socket of the local
network
What steps are
necessary?
Connect to the wireless
network of the supply
module and enter the
password.
The factory preset network
name and password can be
found on the nameplate
(see page 18) on the bottom
of the supply module.
Locally on the supply module,
ensure that the stored network
settings (see page 50) can be
used to log on in the local
network.
On the terminal device you are using, open a JavaScript-capable web browser.
Enter the IP address / URL of the
supply module in the address line
of the browser or call up the direct
link in the portal of the
commissioned service provider
(see page 53).
Enter the IP address stored
in the WLAN settings as
URL in the address bar of
the browser.
If the browser attempts to
connect to this IP over the
Internet, you must disable
the mobile data connection
of your device
Enter the IP address of the
supply module into the address
bar of the browser.
The IP address used by the
network can be read locally on
the supply module if necessary
(see page 50).
Depending on the connection type and quality, it may take up to two minutes before the
login screen appears.
Log in with the corresponding login information.
The factory preset login information can be found on the information plate (see page 18) on the
backside of the supply module.
3.2
Elements of the main screen
Main screen
