12
(Diagram 6.20, Schedule 3 Speed, default 3400rpm)
(Diagram 6.21, Self Priming Time, default 2 mins)
(Diagram 6.22, Self Priming Speed, default 2900rpm)
(Diagram 6.23, Self Priming Enable/Disable, default On)
(Diagram 6.24, Reset)
Short press “Speed 1”, ”Speed 2”, “Speed 3” to switch to “Schedule 1 Speed”, “Schedule 2
Speed” or “Schedule 3 Speed”.
6.4
Long press “Mode” at the time display page under monitoring interface or short press “Mode” at
any display page to enter the edit interface.
Edit Interface
At the edit interface, the changeable area will flash, press “Up” or “Down” to change the value,
press “Speed 1” or “Speed 2” to move left or right.
When editing, short press “Mode” to confirm, or short press “Speed 3” to cancel.
6.5
When there is “OC”,”OV”,”OL”,”OH”,”UV” error, the system will recovery automatically. If two
errors happened in less than 60 seconds interval, the auto recovery time will increase once. If the
auto recovery increase to 3 times, the system will direct to the Error menu, and will not auto
recover.
The Auto Recovery page will display the error details (diagram 6.25) in the first 5 seconds and the
count down details in the next 5 seconds (diagram 6.26)
Press “Start/Stop” button to cancel the count down during the auto recovery process, to activate
the auto recovery immediately. (without activate the auto run
.
If there is error and the variable speed driver is in operation, then after auto recovery the system
will enter the auto start page. The auto start page will display the error details (same as auto
recovery, last for 5 seconds) and count down details (diagram 6.27, last for 5 seconds). At any
time, short press “Run” to cancel the procedures and auto recover immediately (the variable
speed driver will default Off).
Auto Recovery
