1 Pump Installation
-
Please install on a level vibration free surface.
-
Allow use of short, direct suction pipe. (To reduce friction losses & don't install the pump at more
than 3m geometrical height from water level)
-
Allow for gate valves in suction and discharge piping if required.
-
Have adequate floor drainage to prevent flooding.
-
Protect from excess moisture.
-
Allow the adequate access for servicing pump and piping.
NOTICE:
Pump suction and discharge connections have molded in thread stops, DO NOT try to screw pipe in
beyond these stops.
1.1 Operation
The pump is fitted with a wide range of settings to suit any filtration requirements. The controller is
used to program a range of motor speeds and settings described as "Schedules" inthe program. To
program the pump go to page 5 for easy description of how this is done.
NEVER
run pump dry!
Running pump dry may damage seals, causing leakage and flooding! Fillpump with water before
starting motor.
Before removing lid:
-
STOP PUMP before proceeding.
-
RELEASE ALL PRESSURE from pump and piping system.
-
NEVER tighten or loosen screws while pump is operation.
-
Do not block pump suction!
1.2 Priming Pump:
-
-
In a flooded suction system (water source higher than pump), pump will prime itself whensuction
and discharge valves are opened.
-
If pump is not in a flooded suction system, unscrew and remove pump lid and fill
with water.
Release all air from filter and piping system: see filter owner manual.
NOTICE: Tighten pump lid by hand only.
4
2. User’ s Guide
2.1 Overview
This controller match with the variable speed drive for the swimming pool variable speed pump,
Functions as shown below:
1) Timer: Built in real time cloc.
2) Control Parameters: Power usage and motor running speed (RPM) display.
3) Preset Running Speed: 3 preset running speeds.
4) Parameter Setting: Real time clock, 3 preset running speeds, 3 schedule settings, self priming
setting.
5) Error Display: Over Current, Over Voltage, Under Voltage, Overheating fault code.
6) Auto Recovery: Over Current, Over Voltage, Overheating, Power failure, restore to the settings
before the error.
7) Power Failure Recovery: When power resume from failure, will restore to the settings before the
power failure.