ENGLISH
19
Apply a thin layer of wax (car wax or similar) to the work table and upright. This helps to keep these
parts clean.
The power cord must be replaced immediately if it is worn or damaged in any way.
All bearings are pre-lubricated at the factory and require no further lubrication.
Lubricate the gear rack, the mechanism for height adjustment and keyways in the spindle regularly.
MAINS CONNECTION
1.
Connect the machine to the mains in compliance with current regulations.
2.
Use a separate mains circuit for your machines and tools. The dimensions of the conductors in this
circuit should not be less than 1.5 mm. The circuit is protected with a slow-blow fuse of max. 10
amps.
Explanation of terms in the figures on page 11:
3-phase control circuit =
Control circuit for 3-phase mains power.
Single phase control circuit =
Control circuit for 1-phase mains power.
Suggestion =
Proposal.
Equipment boundary =
Interface for the equipment.
DIAGRAM/SPARE PARTS LIST
To order spare parts, contact your dealer.
Jula reserves the right to make changes. In the event of problems, please contact our service
department.
www.jula.com
