IT
EN
SI
HR
57
7.2. Setting up the appliance
Place the appliance in an appropriate location (see also section “3.3.1. Location”
on page 46).
Ensure that the appliance is level, compensate for any unevenness in the floor by
screwing in the screw feet.
Level the refrigerator with a spirit level.
To fully open the door, the room dimensions stated in the following figures must be
available.
ca. 54 cm
ca. 10 cm
ca. 103 cm
ca. 88 cm
ca. 5-7 cm
10cm
10 cm
7.3. Removing and reinserting the wire shelf
To remove the wire shelf (6), open the door fully.
Lift the wire shelf upwards with both hands and remove the wire shelf from the
cooling chamber at a slight angle.
To assemble the wire shelf, proceed as follows:
Insert the wire shelf into the guide rails and push in as far as it will go.
8. Operating the appliance
Connect the appliance to an earthed mains socket. The local mains voltage must
match the voltage stated in the technical specifications for the appliance.
The temperature control (8) setting automatically adjusts the temperature setting in
the cooling chamber and ice cube compartment (1).
The refrigeration temperature can be set as follows:
0
: The appliance is switched off
1–2
: Refrigeration temperature at lowest setting
3–5
: Refrigeration temperature at medium setting (standard)
6–7
: Refrigeration temperature at highest setting
Fluctuating ambient temperatures can cause the energy consumption and temper-
ature inside the refrigerator to rise.
Summary of Contents for MD 37148
Page 37: ...38 ...
Page 105: ...106 ...
