Medion MD 37148, User Manual

Page: 55 / 138

56

Use a Phillips screwdriver or a spanner (width across of 8 mm) to loosen the
screws on the upper hinge (c).

Remove the screw hole cover (i) on the left-hand side, for example using a flat-
head screwdriver.

Remove the blind plug for the hinge pin (h) from the left-hand side of the appli-
ance door and insert it in the hole on the right-hand side.

Place the refrigerator on its back.

Unscrew the lower hinge (d) and then unscrew the adjustable foot (g).

Screw the lower hinge on the left-hand side again. Screw in the adjustable foot
(g) on the right-hand side.

Stand the appliance upright again. While doing so, hold the appliance door
quite firmly in place.

Before screwing the upper hinge back on, ensure that the door closes flush with
the appliance housing horizontally and vertically so that all seals close.

Then put the upper hinge (c) back in place and screw on the hinge with the
screws (b). Use a Phillips screwdriver or spanner (width across of 8 mm) to tight-
en the screws.

Then place the hinge cover (a) and the screw covers (i) back into position.
Please note: The door seal adapts to the new door hinge after a few
hours.
If tilted to an angle of more than 40° during transport or when changing
the door fittings, wait 4 hours before connecting it to the mains and
switching it on to enable the refrigerant circuit to settle.