Appendix
59
Mounting on (Bicycle) Handlebars
You can attach your navigation system to a bicycle as an
op-
tional
additional feature. A special holder is needed to do this.
The installation is explained in the following.
1.
Release both the screws connecting
the clamp to the holding plate with
the hexagon key.
2.
Remove the rubber ring and wind it
around the handlebars.
3.
Position the clamp on your bicycle
handlebars, by pulling it across the
handlebars from below.
4.
Put the holding plate back onto the clamp and retighten
both the screws.
5.
Seat the holder for the navigation system on the holder
plate until it locks into place audibly. Please pay attention to
the fact that the holder must only be seated in
one direction
.
6.
Now place the device on the holder. You must pay attention
to firm positioning.
Note:
Your navigation system could also be equipped
with a different bicycle mounting, where the attach-
ment of mountings can vary slightly, according to the
version.
i
Holding plate
Hexagon key
Clamp
