Medema Mini Crosser M1 Cabin, Service Manual

Page: 24 / 66

Service manual P9-0151-S 24 of 66 Version 1.0.3/2018
Medema Production A/S
Problem Possible causes Solution
The ready lamp on the
charger does not light up
even though the charger
has been on for 10-12
hours.
There has been a power
cut.
The charger is doing a
top-up charge.
There is a problem with
the batteries.
There is a fault in the
charging plug for the Mini
Crosser
Reconnect the charger
and repeat the charging
process.
Check again after half an
hour.
Contact supplier.
Push the charging plug all
the way in and repeat the
charging process.
The ready lamp on the
charger lights up even
when partly discharged
batteries are connected.
The fuse in the charger
has blown.
The switch in the charging
plug is malfunctioning.
Contact supplier.
Contact supplier.
Read the operating
instructions for the
charger
The charging lamp
indicates a fault:
Read the operating
instructions for the
charger.
The charging plug has not
been inserted or there is a
mains fault.
The battery voltage is too
low for charging to start.
Push the charger plug in
or contact the supplier.
Contact supplier. Read
the operating instructions
for the charger.
The heater doesn’t work. Need paraffi n/diesel.
The fuse has blown
Put on paraffi n og diesel.
Change the fuse.
Read the Eberspäcker
user
guide for more
information.
The washer doesn’t work. Washer fl uid i missing.
The fuse has blown.
Put on washer fl uid.
Change the fuse.
The windscreen wiper
doesn’t work.
The fuse has blown. Change the fuse.
If there is an electronic fault, a number of lamps in the battery
indicator will light up. The following table shows what they
mean.
Lamps Causes Remedy
1 lamp The batteries need charging
or the connection to a battery
is poor.
Check all connections between
the controller and batteries. If
these are fine, try charging the
batteries
2 lamps Poor connection to the motor. Check the connection between
the motor and controller. Contact
supplier.
3 lamps Short-circuit between
the motor and a battery
connection.
Contact supplier - say how many
lamps are lit.
4 lamps Not in use
5 lamps Not in use