Medema Mini Crosser M1 Cabin, Service Manual

Page: 25 / 66

Service manual P9-0151-S 25 of 66 Version 1.0.3/2018
Medema Production A/S
Lamps Causes Remedy
6 lamps The S180 is prevented from
driving. Inhibit 2 is active. This
may be due to the battery
charger being connected, the
plug to the thermal switches
being disconnected, a fault
in the thermal switch or the
scooter is overheating.
Stop the unit and wait 3-5 minutes
before restarting. Turn the key to 0
and then to 1 to reset the fault.
Contact supplier.
7 lamps Accelerator fault. Make sure that the accelerator is
in neutral when the Mini Crosser
is turned on.
8 lamps Controller fault. Contact supplier.
9 lamps Poor connection to motor
brake.
Magnetic brake is
disengaged.
Check the connections from brake
to controller, or push the brake
lever up.
Check that the vehicle is not
disengaged.
10 lamps The controller has been
supplied with a high voltage
in excess of 38 V. Usually
seen in the case of a poor
connection.
Check all connections from the
batteries to the controller.
Running
lights
Charger is connected. Remove charger.
Programming unit
The Mini Crosser’s running characteristics can be partially
altered using a type SP1B programming unit via PC and the PC
programming package for S180.
NB! SP1B cannot be used to change the speed, which can only
be done using the PC program.
Please note that the speed, deceleration, throttle gain and
motor compensation settings must not be increased. They
have a major influence on user safety and the durability of the
product.
If you have not received instruction in how to use the
programming unit, we strongly advise against trying to make
changes. The standard driving parameters for the various
scooter models can be found on the next page.
The latest standard parameters can be found on our website at
www.minicrosser.dk