Medema Mini Crosser M1 Cabin, Service Manual

Page: 23 / 66

Service manual P9-0151-S 23 of 66 Version 1.0.3/2018
Medema Production A/S
Troubleshooting
The following is a list of various problems that we are frequently
asked about. Possible causes and solutions are given.
Problem Possible causes Solution
The Mini Crosser will not
go.
The battery indicator is
not lit.
The key has not been
turned to start.
The batteries are
completely flat.
The control fuse has blown.
The main fuse has burnt
out.
Turn the key and wait 5
secs. before activating the
accelerator.
Charge the batteries.
Change the fuse.
Contact supplier.
The Mini Crosser will not
go.
There is a light in the
battery indicator.
The Mini Crosser has
been overloaded.
The handbrake is on.
There is a fault in the
electronics.
The batteries are flat.
The charging plug has not
been removed.
Wait approx. 1 min. before
trying again. The vehicle
must be turned off (See
section about fuses)
Release the handbrake.
Contact supplier.
Contact supplier.
Remove the charging
plug.
Driving speed is too low. The speed selector is on
slow.
The electronics are
overloaded.
There is too little air in the
tyres.
Change to a faster speed.
Stop and wait a few
minutes before starting.
Pump the tyres up to the
right pressure.
The driving distance per
charge is too short.
There is a problem with
the batteries.
Low temperature.
There is a problem with
the charger.
There is too little air in the
tyres.
The charging method is
wrong.
Charge the batteries and
check that the green
lamps on the charger light
up before driving off.
Contact supplier.
Pump the tyres up to the
right pressure.
Read the operating
instructions.
The charging lamp on
the charger does not light
up when the charger is
connected to the mains
and Mini Crosser.
(Read the operating
instructions for the
charger)
No power to the switch.
Fault in cable.
Fault in charger.
Turn the switch on.
Contact supplier.
Read the operating
instructions.
Contact supplier.