TA3H, TA3SH & TA3.5SH
Page 9 - 23
9. Maintenance
(c)
Parking Brake
The parking brake lever, Figure 9.24 is of the over centre type with a safety release lever
preventing the parking brake being released accidentally.
Figure 9.24
1.
Parking Brake Lever
2.
Release Lever
(d)
Parking Brake Test
With the parking brake adjusted correctly the engine should stall without movement of the
machine. The machine must not be used if it fails the parking brake test, it must be checked
immediately by a qualified engineer. Test as follows:-
PROCEDURE
1.
Place the machine on level ground.
2.
Make sure there is 20 metres (65 feet) of clear area in front of the machine.
3.
Apply the parking brake.
4.
Start the engine.
5.
Select ‘Fast’ speed (‘Hare’ light comes on) lower switch LH side of dash.
6.
Select ‘Forward’ top switch left hand side of dash.
7.
Increase engine speed gradually up to maximum RPM for 2 - 4 seconds.
8.
If the machine moves abort the test immediately and have the adjustment rechecked by
a qualified service engineer.
b
WARNING
Do not use the machine until the parking brake is adjusted correctly and passes the above test
procedure. Make sure all personnel are clear of the area before performing the parking brake
test. Danger of the machine moving unexpectedly.
COV00080
1
2
Summary of Contents for TA3.5SH
