www.mdcusa.com
Ph: 833 632 8721
63
•
Irritation of skin and eyes in case of contact with decalcification agent. Wear protective
gloves, eye protection and face protection to avoid contact.
•
Fill the water inlet filter with 6 AquaGo decalcification tablets (content of one blister pack).
•
Re-insert the water inlet filter. See Step 9 in “Draining the water and cleaning the water inlet filter” on page 15.
• Switch ON the appliance at the POWER switch.
c) Introducing the decalcification agent
Tasks outside the RV
d) Filling the water system
Tasks within the RV
• Turn on fresh water supply or switch on water pump
•
The decalcification tablets dissolve in water quickly (approx. 10 minutes). So that the decalcification agent is not
rinsed out, when filling, run the water only as long as necessary. The decalcification tablets color the water slightly
red.
• Fill the water system.
- Open all water-release points, e.g., hot water faucets, showers, toilets.
- Once water flows uniformly, the water system is vented.
- Close the water-release points.
You must bleed the water system thoroughly otherwise the circulation pump cannot circulate the decalcification solu
-
tion.
e) Starting decalcification
Tasks within the RV
• Set the control panel to “Clean”.
- If decalcification does not start, switch the appliance on at the POWER switch.
•
Decalcification takes about 3 hours (during this time, you do not have to do anything).
•
Decalcification is indicated by a slow flashing (1 s on, 1 s off) of the status LED 3 (Fig. 9) on the control panel.
•
During decalcification, the control pa¬nel must remain set to “Clean”.
•
Decalcification is complete when the status LED 3 (Fig. 9) flashes quickly on the control panel.