www.mdcusa.com
Ph: 833 632 8721
59
6. Leave the hot water faucets open in order to depressur-
ize and vent the water system.
7. Open the latch with your thumb while pulling
the Easy Drain Lever down as far as it will go.
8. Remove the water inlet filter (or heating cartridge)
as shown in Fig. 10 and rinse it with clean water.
9. Inspect the O-rings on the water inlet filter
(or heating cartridge) for cracks. Change the filter
assembly (spare part, refer to “APPENDIX C – Spare
Parts (all models)” in manufacturers booklet)
if there are cracks.
If, during installation, it is difficult to install
the filter cartridge, use a small amount of soap on
the O-rings. Never use grease because the O-rings
are not resistant to grease.
10. Install the water inlet filter as shown in Fig. 10.
Observe the correct installation position and close
the Easy Drain Lever until it is locked by the latch.
You can hear a “clicking” sound as the
Easy Drain Lever engages.
11. Insert and close the access door (refer to
“Closing the access door” on page 52).
Injuries caused by the Easy Drain Lever!
When the Easy Drain Lever is folded out, it
protrudes beyond the side wall of the vehicle.
• When walking past or stooping down, make sure
that you and others have sufficient distance.
CAUTION
Danger of crushing/pinching of fingers when the
Easy Drain Lever is closed!
•
Never put fingers between the Easy Drain Lever
and water inlet filter or latch.
CAUTION