
McHale
991 High Speed
Round Bale Wrapper
60
10.4 Adjusting table magnets
If the table does not stop or index to the loading position, it is possible to modify the
position of the relevant magnets to rectify this.
10.4.1 Table stop position magnet
If the table does not stop in the correct position in line with the chassis, it is possible to
move the magnet that controls the stop position. However, it must be checked first that
the machine is operating at the correct speed, has a bale on the table and the plastic
film is attached, as all of these factors will have a bearing on where the machine stops.
The magnet may be adjusted as follows:
1.
Tip up the table and fit the safety bar
2.
Identify the magnet to be changed. There are two sets of magnets near the
outside of the table. The magnets that require adjusting are positioned furthest
away from the cut & hold.
3.
Loosen the M6 bolt and nyloc nut holding the magnets in position
4.
If the table does not turn far enough, push the magnets in the direction shown
5.
If the table turns too far, push the magnets in the direction shown
6.
Tighten the M6 bolt and nyloc nut (Do not overtighten as the magnets may
crack or shatter)
WARNING: When performing maintenance, ensure the safety bar
is fitted securely while the table is elevated!
1.
Start the tractor/power unit and elevate the table fully, by operating
the tip up function.
2.
Remove the R-pin and swing the safety bar into position. Secure it
onto the chassis using the R-pin.
3.
Stop the tractor/power unit and ensure that it cannot be restarted,
while working on the machine.
4.
Secure the safety bar back into its storage position, when
maintenance work is complete.
5.
Lower the table by operating the tip down function.
2
1 & 3
1 & 3
1 & 3
1 & 3