
McHale
991 High Speed
Round Bale Wrapper
40
7.5 Electronic control box features
7.5.1 Working display
When the electronic control box is first switched on it displays “Expert Series”, with the
software version number beneath.
After a short delay the working display (Screen 1 of 4) appears. Press Enter (Button 3)
to toggle between the screens. The working display contains two lines:
1.
The upper line displays the machine status i.e. manual or automatic, the
current wrap count and the target number of wraps. The upper line remains
constant in all screens.
2.
The lower line changes in each of the working display screens, as follows:
(a)
Screen 1 displays the current bale counter and its counter total
(b)
Screen 2 indicates whether 1 roll of film or 2 rolls of film mode is selected
(c)
Screen 3 displays the voltage and the table speed in rpm
(d)
Screen 4 indicates whether there is a bale on the wrapper (BALE 1) and
a second bale being carried on the load-arm (BALE 2).
Screen 4 is only available if Auto Load is set to On or Semi. Screen 4 indicates with an
arrow whether there is a bale on the wrapper (BALE 1) and a second bale being carried
on the load arm (BALE 2).
NOTE: Continuous Cycle and Auto Load sequence “ON” settings
must be confirmed every time
Every time the electronic control box is turned on Enter (Button 3) must
be pressed to confirm the Continuous Cycle
, if these were previously set
to on. If you don’t press Enter for each sequence, it will default the setting
to OFF!
Working display (Screen 1)
Working display (Screen 2)
Selected bale counter
Counter total
1 or 2 rolls of film mode selected