
McHale
991 High Speed
Round Bale Wrapper
43
7.6.2 Liftarm position
The lift arm must be down before a cycle can be started. If not then a 'Liftarm Position'
warning is displayed.
7.6.3 To set wraps
To change the desired/target number of film wraps:
1.
Press the Down Arrow (Button 4) twice, from the working screen, to display the
To Set Wraps Screen
2.
Press Enter (Button 3) to move to the Use To Set Screen
3.
Use the Up and Down Arrows (Buttons 1 & 4) to make changes. When the
target number of wraps is displayed, return to the working display by pressing
ESC (Button 2) twice.
7.6.4 Operator setup
To enter the Operator Setup Menu:
1.
Press the Down Arrow (Button 4) three times from the working screen
2.
Press Enter (Button 3) to move to the Operator Setup options:
Slow Down Time
Wrapping Sequence/Program
Film Sensor
Display Contrast
Continuous Cycle
Auto Load Setup
Remote Type
3.
Use the Up and Down Arrows (Buttons 1 & 4) to select an item, press Enter
(Button 3) to adjust the current selection/setting.
Slow down time
This setting determines when the table goes into slow down speed at the end of a
wrapping cycle. The adjustment range is from 1 to 4 sensor pulses. (There are 2 sensor
pulses per table revolution). To change the slow down time:
1.
Press the Down Arrow (Button 4) three times
2.
Press Enter (Button 3) once to move to the Select Slow Down Time Screen &
press Enter again to adjust the setting
3.
Use the Up and Down Arrows (Buttons 1 & 4) to change the value, press Enter
(Button 3) to save the new setting.