McFarlane HDL-100-44 Series, Operator'S Manual And Set-Up Instructions, Page: 28 / 55

28
Figure 20
Final Adjustments
Refer to Operating Instructions on Page 11 regarding lowering the section into field position.
1. Unfold the unit into the field position and fully extend all cylinders.
2. Slowly fold the unit into the transport position. Be sure the Wing Frames engage the ramp on
the Wing Rest and fully sit on it. It may be necessary to adjust the Wing Rest back/forward.
It may also be necessary to adjust the stroke control collar on the 4x8 main lift cylinders. If
the wings are too low, extend the collar until the wings engage the Wing Rest ramp and
secure the lock collar with the snap ring.
3. Unfold the unit into field position and pull the completed unit ahead a few feet to check that
everything is properly assembled and that nothing is binding or misaligned. Check to make
sure that all fasteners are tight.
4. Be sure to wrap the chains around the wing tubes for security during transport.
5. With the unit in the transport position, attach the red and amber reflectors at the widest visible
points. The red reflectors should be visible from the rear of the unit, and the amber reflectors
should be visible from the front of the unit.
6. Do not detach the unit from the tractor unless the jack stand is down and the wings are
secured in the wing rests.
7. After the first few hours of operation, check all fasteners and tighten if necessary. Include
wheel lugs.