21
Figure 11
Attach the Wing Cable Lift Assembly
1.
Bolt the Cable Lift Bracket to the Main Frame approximately 24” from the front of the frame
side tube. Use two 1/2 x 3 x 7 U-bolts and lock nuts. Do
not
tighten yet.
2.
Bolt the Cable Lift Angle to the Cable Lift Bracket. Use the 5/8 x 4 bolt and lock nut.
3.
Attach the Cable Lift Spring to the tabs on the Cable Lift Bracket and the Cable Lift Angle by
placing a lock clip on each end of the spring. Use 7/16 x 1 1/2 bolts and lock nuts to fasten the
lock clips and spring to the tabs.
4.
Attach the 1/4 x 6-link lift chain to the Cable Lift Angle with a small shackle.
5.
Adjust the assembly so that the chain on the Cable Lift Angle hangs directly above the cable
when the cart is in the field position and the cable is pulled tight.
6.
Using a small shackle, attach the lift chain to the Wing Cable.
7.
Rotate the wings into the transport position. If the cables are touching the ground, the cable
lift bracket assembly needs to be moved until the cable is clear of the ground. When properly
adjusted, tighten all bolts.
Summary of Contents for HDL-100-44 Series
