McFarlane HDL-100-44 Series, Operator'S Manual And Set-Up Instructions, Page: 16 / 55

16
6. Attach two 69” (116 through 130 models) or 90” (132 through 140 models) hoses from the
rod end of the 4 x 8 cylinders to the rod end of the 14” wing fold cylinders.
7. Attach the 265” (116 through 122 models), 312” (124 through 130 models) or 360” (132
through 140 models) to the rod end of the 4 x 8 cylinder on the right hand side of the unit.
Attach the 276” (116 through 122 models), 324” (124 through 130 models) or 372” (132
through 140 models) hose to the base end. Run both hoses to the hitch.
8. Secure all hoses to the frame to prevent damage between moving parts or from contacting the
ground.
Attach the Lift Arms (8-bar model only)
1. Refer to the appropriate layout diagram in appendix C. Note the dimensions for the lift arm
locations. Place a mark on the center bar and wings at the locations for each of the lift arms.
2. Center a lift arm on each of these marks and secure using 1/2 x 7 1/2 bolts and lock nut.
3. Bolt an 8-link chain to the front pull point using a 1/2 x 1 3/4 bolt and lock nut.
4. Bolt a 7-link lift chain to the rear lift point using a 1/2 x 1 3/4 bolt, square washer, flat washer
and lock nut. The square washer goes between the bolt head and the chain.
5. Attach the brace angles as shown using 7/16 x 1 1/4 bolts, flat washers and lock nuts.
Figure 6