17
Attach the Lift Arms (4+4 model only)
1.
Refer to the appropriate layout diagram in appendix C. Note the dimensions for the lift
arm locations. Place a mark on the center bar and wings at the locations for each of the lift
arms. Be sure the dimensions are for your unit.
2.
Center a lift arm on each of these marks and secure using 1/2 x 7 1/2 bolts and lock nut.
3.
Bolt an 8-link chain to the front pull point using a 1/2 x 1 3/4 bolt and lock nut.
4.
Bolt the Rear Pull Point to the Lift Arm by first placing a square washer on the 1/2 x 2 bolt
and inserting the bolt through the 7-link lift chain. Then secure the Rear Pull Point to the
Lift Arm with a 1/2 x 2 bolt, flat washer and lock nut.
5.
Place the appropriate Brace Angle across the Lift Arms and bolt through the Rear Pull
Point, the Lift Arm and the Brace Angle using a 7/16 x 1 1/4 bolt, flat washer and lock nut.
6.
Bolt an 8-link chain to the Rear Pull Point using a 1/2 x 1 3/4 bolt and lock nut.
Figure 7
Summary of Contents for HDL-100-44 Series
