Maintenance
9 - 3
Adjusting System Pressure
Remove the right side cowling to gain access to the hydraulic pump.
Start the engine and select high speed.
The system pressure is 2000 psi. Use the system pressure gauge (
B
) next to
the hydraulic filter to set the system pressure.
To adjust the pressure, loosen the jam nut and turn the compensator (
A
)
to the right to increase the pressure, or to the left to decrease pressure.
Retighten the jam nut.
NOTICE:
Do not adjust screw on opposite side of pump.
This machine has moving parts when the machine is in
operation. Use caution when making pressure adjustments
while the machine is running and avoid the moving parts.
Failure to do so could result in minor or moderate injury.
TX05179-09-22-16
¡CUIDADO!
ОСТОРОЖНО
ATTENTION
PH0
56
42
-0
9-
21-16
PH0
56
44
-0
9-
26
-16
A
B
Setting Engine Speed
With the engine running at max speed plug the heater in.
Check the voltmeter above the heater receptacle.
Adjust throttle cable sheath until voltage is correct.
The voltmeter should read 240V±5.
When the engine speed is adjusted, the hydraulic flow rate needs to be
checked to verify it is within range.
Check hydraulic flow rate:
Remove the left side cowling to gain access to the hydraulic pump.
Disconnect both facer hose quick disconnects from the facer. Install flow
meter kit (AT1214801) in between the two facer hoses.
Start the engine to check hydraulic flow rate. The flow rate should be 8 gpm
(± 0.1).
To adjust the flow, loosen the jam nut and turn the screw (
A
) until the flow
rate is 8 gpm (± 0.1). Retighten the jam nut.
TX05362-04-09-18
PH0
2712
-10
-2
5-0
4
PH0
56
64
-0
4-10
-17
A
CD018
63-0
4-12
-17
