Positioning Pipe In Machine
Swing the facer into place. With the carriage control valve lever,
move the carriage toward the fixed jaws, while watching the gap
at each end of the facer rest buttons. When the pipe is in contact
with the facer, this gap indicates the amount of material that will
be trimmed from the pipe end. Assure sufficient material will be
removed for a complete face off. Tighten the clamp knobs on the
outside jaws. Hand tighten the inside clamp knobs.
'
TX00372-9-15-94
CD018
61-11-16
-16
Operation - General
3 - 4
Hydraulic Clamping
The controls are located on the end of the inner fixed jaw. The left
knob
(A)
opens/closes the fixed jaws and the right knob
(B)
opens/
closes the movable jaws.
To unclamp the jaws:
With your free hand, hold the tie bar between two cylinders.
Rotate the valve knob up to unclamp.
Pull the tie bar towards operator until the cylinders come to rest.
To clamp the jaws:
Push the cylinder tie bar toward the jaws until cylinders are vertical.
Rotate the valve knob down to clamp.
Hi/Lo adjustment:
Unclamp and open the inner jaw on the high side. Make
adjustments to the Hi/Lo by adjusting the stop on the bottom of the
inner upper jaws and then reclamp the jaw.
Prior to starting the machine, always ensure that the
hydraulic clamping directional valves are both in
the center (neutral) position to eliminate undesired
clamp cylinder movement during startup.
TX05201-12-06-16
CD018
88-12
-06
-16
CD018
87
-12
-06
-16
¡CUIDADO!
ОСТОРОЖНО
ATTENTION
A
B