McDATA OPENconnectors, Command Line Interface Manual

Page: 43 / 170

CLI Commands
config
2
2-11
FRQILJSRUWVSHHG
6\QWD[
speed portNumber portSpeed
3XUSRVH
This command sets the speed for a port.
'HVFULSWLRQ
A port can be configured to operate at 1 Gbps, 2 Gbps, or a negotiated
speed. The port speed can be set only to 1 Gbps if the switch speed is
1 Gbps. An attempt to set the port speed to 2 Gbps or to negotiate in a
switch with a 1 Gbps switch speed results in an error message.
If the port speed is set to negotiate, the port and the device to which it
is attached negotiate the data speed setting to either 1 Gbps or
2 Gbps.
Port speed changes temporarily disrupt port data transfers.
3DUDPHWHUV
This command has two required parameters.
&RPPDQG([DPSOHV
Root> config port speed 4 2g
Root> config port speed 6 negotiate
portNumber Specifies the port number. Valid values are:
0–15 for the Sphereon 3016 and 3216
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0–63 for the Intrepid 6064
0–127 and 132–144 for the Intrepid 6140
portSpeed Specifies the speed of the port. Valid values are
1g, 2g, and negotiate.