McConnel ROBOPOWER, Operator'S Manual

Page: 88 / 138

7528%/(6+227,1*&2'(6'2&-2+1'((5((1*,1(
631)0,&2'(6
The troubleshooting fault codes stored and active are displayed on the John Deere
troubleshooting indicator, in conformance with standard J1939, in the form of two part codes, as
illustrated in the tables on the following pages.
7KHILUVWSDUWLVDQXPEHURIWKHVXVSHFWSDUDPHWHU631IROORZHGE\DQLGHQWLILFDWLRQFRGHRIWKH
HUURUPRGH)0,7RGHWHUPLQHH[DFWO\ZKDWWKHSUREOHPLVERWKSDUWVRIWKHFRGHDUHQHFHVVDU\
631DQG)0,
7KHVXVSHFWSDUDPHWHUQXPEHU631LGHQWLILHVWKHV\VWHPRUWKHFRPSRQHQWSUHVHQWLQJWKH
SUREOHPHJ631LGHQWLILHVDSUREOHPLQWKHHQJLQHFRRODQWWHPSHUDWXUHFLUFXLW
)0,LGHQWLILHVWKHW\SHRISUREOHPWKDWKDVDULVHQHJFRGH)0,LQGLFDWHVDYDOXHKLJKHUWKDQ
the norm. The combination of SPN 000110 and FMI 03 indicates an “excessive engine coolant
temperature sensor input voltage”. A corrective action is then displayed "check the sensor and the
cabling". If this check does not lead to a solution of the problem in the engine, contact a dealer
ZKRLVTXDOLILHGWRFDUU\RXWPDLQWHQDQFH
Always contact
0F&RQQHO6HUYLFH
to get the help you need in the processing of troubleshooting
error codes displayed regarding the engine.
)0,&2'(6
FMI code FMI name FMI code FMI name
0 Very high 11 Activated
1 Extremely low 12 Error
2 Not valid 13 Problem
3
Over the maximum limit
VSHFL¿HG
14
Wrong message
4
Under the minimum limit
VSHFL¿HG
15
Slightly elevated
5 High resistance 16 Moderately high
6 Low resistance 17 Slightly low
7 Discrepancy 18 Moderately low
8 Signal absent 19 Communication error
9 Communication loss 31 Existing condition
10 Anomalous change
631&2'(
SPN code SPN name
27 EGR valve position signal
28 Digital accelerator signal
29 Secondary analogue accelerator signal
51 Air throttle valve actuator position signal
54 Accelerator signature
91 Main analogue accelerator signal
94 Low pressure fuel signal
96 Fuel level
97 Condensate in the fuel
75