McConnel 1.5M, Operator'S Manual, Page: 24 / 32

13
OPERATION
It is recommended that forward speed is kept to a minimum when starting work in order to
retain the correct working speed of the blades. Set the angle of the Multisaw at right angles
to the work and adjust machine position so that branches meet the saw blades ‘straight on’.
Wherever possible try to keep the blades running vertical in relation to the direction of travel,
this will help prevent them from ‘distorting’ during operations.
The machine is equipped with a skid to prevent the lower blade from contacting the ground.
Should small branches, debris or unwanted material get stuck in the blades of the machine,
the machine and the tractor must be switched off and the starting key removed before
attempting to clear the blockage. If necessary, remove the belt cover to gain better access to
the blockage; replace cover immediately before starting or using the machine.
Never attempt to run the machine with the belt cover removed.
Great care must taken when attempting to clear debris from the
blade and/or belt area of the machine; sharp components and
numerous pinch risk points exist in these locations. Safety gloves and safety eyewear
must be worn and wherever possible the use a suitable tool should be employed to
remove any debris to ensure hands and fingers are kept clear of any risk areas.
When in charge of the machine always obey the following rules;

Always inspect the work area prior to operation and remove any dangerous materials.

Never operate the machine with persons or animals in close proximity.

Stop operations and switch off the machine if persons or animals enter the work zone.

Ensure all cab guarding is in place and the tractor windows are kept shut.

Only operate the machine at the correct blade speed.

Never use the machine in excess of the maximum oil pressure in the hoses.

Never stop the engine with the PTO engaged.

Never transport the machine with the PTO engaged.

Never transport the machine without the blade protection guards fitted.

Never transport the machine with the blades running.

Never approach the machine when it is running, always switch it off and stop the tractor.

Always remove the tractor ignition key before leaving the cab.

Never use the machine to perform tasks it was not designed for.

Always lower the machine to rest on the ground with blade protection guards fitted when
the unit is parked up or not in use.