Installation and use
SOLID CONTROL MCK 2000
38
6.5
Automatic calibration of the “C” parameter
The automatic calibration of the “C” parameter is carried out by covering an
established distance of 100 meters and following the listed routine:
access progr
amming (see chapter “
” on page
25) and display
parameter “C”;
press
key to start counting;
cover the distance of 100 metres;
press
key again to stop counting. The impulses are automatically
programmed in parameter “C” (in
case of wrong storing, the Computer shows the
error message “err” and returns to the programming phase by displaying the
previous value stored;
during counting, the display will show the number of impulses obtained.
N.B.:
it is recommended to perform the operation at least twice, checking that the
value detected is always the same
1 pulse.
