Installation and use
SOLID CONTROL MCK 2000
20
KEY
FUNCTION
Multifunction key:
a quick pressure allows to select the value to be displayed.
Keeping the key pressed for <3> seconds allows to reset
the totalisers and reload the counter of the Kg left in the
hopper.
Key for activating the function “field border” on the right section.
It is operating only in the Automatic mode, and allows to
decrease the quantity in Kg/Ha of the right section to the
percentage programmed into parameter
“bC” (see chapter
” on page
The corresponding LED lights up when the function is
operating.
Switch for opening and closing the right section:
enable the automatic or manual adjustment respectively on the
slit left to right; in OFF position they cause the slits to close
completely.
Momentary switch for right section manual adjustment:
allow the manual adjustment of the opening of the slits, while in
automatic operating mode they allow to temporarily vary the
target dose for the relevant sector (see also “dE” parameter
programming in the “Programming” paragraph).
Programming keys:
turning on the computer and simultaneously keeping the
key pressed, enters the programming phase (see
pressing the
key when the computer is still turned on,
allows to program the Kg/Ha to be distributed, the type of
product used and the total Kgs loaded in the tank (see
Tee
and
keys allow to increase and decrease (one
digit after the other one) the values displayed (by pressing and
holding the key, the variation of the values will be more quickly).
