Installation and use
SOLID CONTROL MCK 2000
25
5. Programming
5.1 Programming of dose to be sprayed
This programming phase can be accessed with the computer on, both in automatic or
manual mode.
Press the
key briefly to display the programmed target value (it appears for a
few seconds).
To enter the programming phase press the
key for about 2 seconds, or until
the numeric value only is shown on the display.
The “P” letter flashes on the
display when the key is released.
Edit the value using the
and
keys, and confirm by pressing the
key.
PARAMETER PROGRAMMING
P
DPA to distribute with DPA system.
Setting field
: 0
2000
step
: 1
default
: 200
5.2 User programming
This programming phase can be accessed with the computer on, both in automatic or
manual mode.
To access programming, press and hold the
key (about 5 sec.) until the letter
“P” flashes on the display followed by a number between 1 and 5.
Edit the value using the
and
keys, and confirm by pressing the
key.
Pressing the
key switches to the next parameter.
PARAMETER PROGRAMMING
P
Type of product used. For example, by programming “5” in this
parameter, the computer will use parameters “5A” and “5b” for the
calculations
Setting field
: 1
5
step
: 1
default
: 1
