Installation and use
SOLID CONTROL MCK 2000
43
7.1.1 How to replace the protection fuse
The computer fuse is internal and self-restoring.
If the display goes into protection, it is necessary to:
a.
Disconnect the power supply.
b.
Wait for the fuse to cool (about 30 sec.)
c.
Reconnect the power supply.
If it still does not work, contact the Manufacturer’s service.
7.1.2 How to protect the main connector
In the event of prolonged disuse of the
SOLID CONTROL
, you may wish to
disconnect the main signal connector (Picture 4 - ref. <A> on page 10) from the
wiring harness. We recommend isolating both connectors (of the
SOLID CONTROL
and of the wiring harness) with Nylon. If instead the connectors of the
SOLID
CONTROL
and of the wiring are not disconnected, no protection is required.
7.2 Extraordinary maintenance
!
Warning
Extraordinary maintenance must be carried out by authorized personnel
only.
