![MBRAUN EasyLab Operating Manual Download Page 76](http://html1.mh-extra.com/html/mbraun/easylab/easylab_operating-manual_1752773076.webp)
Operating Manual
Operation instructions
Page12-6
·If a sliding tray is available: Pull out sliding tray; take out material from the tray; then slide
the tray into antechamber.
·If no sliding tray is available: Transfer the material directly into box
·Close outer door
Risk of injury and pollution of environment!
Annoyance by bad sme`ll is expected as soon as any waste gas from inside the glove box
escapes to the surroundings. Environmental pollution and effects detrimental to health,
however, are not known in any standard applications, but cannot be excluded, depending on
the chemicals handled inside the glove box. The manufacturer does not assume any liability.
Refer to section 2.5.6 of this manual for general remarks concerning the safe handling of
chemicals and gases.
When using toxic, radioactive, or material that may burn in air ensure, that the gas enclosed
in the antechamber after opening and closing of the inner antechamber door escapes by no
means to the environment.
When opening doors of large antechambers be sure that the enclosed volume of the
antechamber is still small compared to the volume of the room. Make sure that the room is
well ventilated. (Does not apply to standard systems – the enclosed volume of a standard
antechamber is approx. 70 l). For information about alternative methods please contact the
MBRAUN service department.
Note!
If the system is equipped with a separate vacuum pump, MBRAUN recommends that the
pump is switched off using the control panel when not required. The pump will be restarted
automatically on the next evacuation/refill cycle.