(5)Cable sheath gets inflated.
In addition, the following inspections must be carried out.
(1)Make sure that steel cable is correctly adjusted and securely fastened
to the top of weight plates. Make sure that cable is securely connected to
pulleys and all assemblies are well fixed, all the seven cable strands pass
through the selector bar and screws are well tightened.
(2)Wipe and clean all warning/instruction stickers. (Picture 2)
(3)After some time of use, steel cable may get loose due to stretches.
It can be solved by adjusting the hexagon nut on the head plate in time;
tighten hexagon nut in case of slack. If it fails, cut a small section of the
cable and refasten it. (For adjustment and assembly of steel cable, please
check Assemble Weight Cage, ASSEMBLY INSTRUCTIONS.)
2.Weekly Inspection
Clean upholsteries; clean and lubricate cable rod end; clean and lubricate
guide rods; inspect cable, connecting parts, and cable tension; inspect
cable accessories; inspect pulleys; inspect each weight plate and selector
pin; inspect and lubricate bearings and bushings; inspect seat adjustment
system; test the pop pin.
(1)Clean upholsteries with special detergent.
Note: It must be neutral
detergent. Never use detergent which contains solvent, ethanol,
ammonia or petroleum.
(2)Inspect heim joint and assure that the shoulder screw is well tightened.
If there's noise inside the heim joint, lubricate it with silicone oil as shown
16
Picture 1:
Picture 2:
