MAZZELLA NTM BG7, Operation And Maintenance Manual

Page: 34 / 50

APPENDIX A
COMPUTER BATCH AND LENGTH CONTROLLER
A - 1
COMPUTER BATCH AND LENGTH CONTROLLER
The optional Batch and Length Control Computer is used to control number and length of
panels that your machine produces. It uses an Encoder and Wheel assembly that runs on
the bottom of the panel for measurement. The Encoder assembly is located between the
4
th
and 5
th
bottom Drive Rollers of the machine and the Encoder Cable exits thru the end
cover under the Manual Control Panel assembly.
Batch and Length Controller Connection (Figure 21 & Figure 22)
1. Connect the Main Control Cable (larger connector) to the panel mounted male
connector “A” located in the bottom of the computer on the right side. Make sure that
the key and slot are aligned and carefully start the threads on the connection. Turn
clockwise until snug. Caution:
DO NOT rotate the cable clamp on the back of the
plug to tighten this connection. You must turn the threaded ring of the plug only,
or damage will occur.
2. Connect the Encoder Cable (smaller cable) to the panel mounted Female connector
“B” located in the bottom of the computer on the left side. Again, make sure that the
key and slot are aligned and carefully start the threads on the connection. Turn
clockwise until snug and
DO NOT rotate the cable clamp on the back of the plug to
tighten this connection. You must turn the threaded ring of the plug only, or
damage will occur.
3. Refer to instructions that follow for computer operation.
Figure 21: AMS Box Without Cables