16
NOTE:
Press and hold the “DOWN ARROW” to view the basket (tumbler) RPM.
7) Once the preprogrammed percentage of extraction (dryness level) is reached, the drying cycle will
end, and the Cool Down Cycle will begin.
8) Once the Cool Down Cycle begins at the end of the heat cycle, the light emitting diode (L.E.D.)
display will read COOL DOWN TEMP ___/___MINUTES REMAINING. At the end of the heat
cycle, the dryer will shut off the heat and continue the fan and basket (tumbler) until the Cool Down
Time or temperature is reached.
9) Once the Cool Down Cycle is completed, the Phase 7 OPL microprocessor controller (computer)
will proceed into the Wrinkle Guard Cycle. The Audio Alert tone will sound (for amount set in
Audio Alert On Time). The L.E.D. display will read “WRINKLE GUARD.” The times are fixed
at 2 minutes OFF, 2 minutes ON for a maximum time of 99 minutes. These times are not
programmable. During the ON time, the blower (fan) and the basket (tumbler) will start to rotate
(without heat for 2 minutes). The Phase 7 OPL microprocessor controller (computer) will repeat
this process until the Maximum Wrinkle Guard On Time has expired (99 minutes). The L.E.D.
display will then read “CYCLE DONE” and lockout the dryer functions until the doors are opened.
It will then return to “READY.”
NOTE:
Mechanical functions of the dryer
are
not
allowed during the ON time. The blower (fan)
must be
OFF to perform mechanical functions. However the “STOP/CLEAR”
O
key may
be pressed at any time to end the Wrinkle Guard Cycle. Mechanical functions of the dryer are
allowed during the OFF time.
b. Timed (Manual) Drying Cycle
1) L.E.D. display reads “READY” (no cycle in progress).
2) Press MAN key.
3) L.E.D. display will now read “ENTER DRY TIME 0 TO 99 MINUTES” (defaults to 0). I.E., for
40 minutes, press key “4,” key “0,” and then press the “START/ENTER”
l
key to accept the
value.
4) L.E.D. display will now read “ENTER DRY TEMP __ TO __” (defaults to 100° F [38° C]). Enter
the temperature desired (from 100º F to 200º F [38º C to 93º C] in one-degree increments). I.E., for
182º F (83º C), press key “1,” key “8,” key “2,” and then press the “START/ENTER”
l
key to
accept the value.
5) L.E.D. display will now read “ENTER COOL DOWN TIME 0 TO 99 MINUTES.” I.E., for 10
minutes, press key “1,” key “0,” and then press the “START/ENTER”
l
key to accept the value.
6) L.E.D. display will now read “REVERSE MODE” (defaults to ON). The ON/OFF selection can
be toggled with the “UP ARROW” and “DOWN ARROW.” Once selected, press the “START/
ENTER”
l
key to accept selection.
7) The dryer will now display “PRESS START.” Press the “START/ENTER”
l
key to start the
dryer. The L.E.D. display will read MANUAL DRYING CYCLE, __MINUTES REMAIN.
Summary of Contents for PHASE 7.2
Page 86: ...113162 1 12 23 02 25...
