30
41
24
28
6V/1.000mA
6
Step 3: Assemble the Rear Stand
Attach the rear stand (30) using four M8x16 mm Allen screws (41) at the rear lower end of the aluminium slide
rail (24).
Then slide rear cap (28) onto the end of the slide rail (24).
Assembly
Allen screw – Part 41
M8x16mm
4 pcs
Step 4: Assemble the pedals
Place the right and left pedals (17R & 17L) with the connecting plate (56) onto the bracket on the base frame
(1). Then attach them to bracket on the base frame (1) using two Allen screws M8x25 mm (69).
Allen screw – Part 69
M8x25mm
2 pieces
Mains Adapter
Plug in the connector on the AC mains adapter (51), which is included in
delivery, into the socket on the front of the main frame (50). Then plug the AC
adapter into a wall mains socket.
CAUTION:
Before connecting the mains adapter to the device, always check that it is the
same as the one supplied with the device.
Using another mains adapter may damage the electronic components of the
device for which the manufacturer can accept no liability.
Always plug in the connector with the training device before connecting it to
a wall mains socket. If you disconnect your training device from the power
supply, always disconnect the power cable from the wall mains socket first.
The device may only be connected to a socket that has been professionally
installed and earthed. Do not connect the training device to multiple sockets.
If you use an extension cable, you must ensure that this complies with the
guidelines of the VDE or the equivalent in your country.
To disconnect the mains adapter always remove the plug from the wall
socket first. Only then should you remove the mains adapter from the rowing
machine.
Mains Connection
