Maxon MXT-25, Maintenance Manual

Page: 11 / 61

1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
11
PERIODIC MAINTENANCE CHECKS
Never operate the Liftgate if parts are loose or missing.
WARNING
NOTE:
Make sure vehicle is parked on level ground while performing the
maintenance checks.
Quarterly or 1250 Cycles (whichever occurs fi rst)
Semi-annually or 2500 Cycles (whichever occurs fi rst)
Visually check the platform hinge pins for excessive wear and broken welds. See
PARTS
BREAKDOWN
section for replacement parts. Also, do the
Quarterly or 1250 Cycles
maintenance checks.
Check the hydraulic fl uid level in the pump reservoir. Refer to the
CHECKING HYDRAULIC
FLUID
procedure in the
PERIODIC MAINTENANCE
section.
If hydraulic fl uid appears contaminated, refer to the
CHANGING HYDRAULIC FLUID
procedure in the
PERIODIC MAINTENANCE
section.
Keep track of the grade of hydraulic fl uid in the pump reservoir and never mix two different
grades of fl uid.
Check all hoses and fi ttings for cha fi ng and fl uid leaks. Tighten loose fi ttings or replace
parts as required.
Check electrical wiring for cha fi ng and make sure wiring connections are tight and free of
corrosion. Use dielectric grease to protect electrical connections.
Check that all
WARNING and instruction decals
are in place. Also, make sure decals are
legible, clean and undamaged.
Check that all bolts, nuts, and roll pins are in place. Make sure roll pins protrude evenly
from both sides of hinge pin collar. Replace fasteners and roll pins if necessary.
PERIODIC MAINTENANCE
!
Check for rust and oily surfaces on Liftgate. If there is rust or oil on Liftgate, clean it off.
Touch up the paint where bare metal is showing. MAXON recommends using aluminum
primer touchup paint.
Damaged cylinder seals and contaminated hydraulic fl uid can result from paint-
ing the polished portion of the cylinder rod. To prevent damage, protect the
exposed polished portion of the cylinder rod while painting.
CAUTION
Pump EP chassis grease in each lube fi tting on the cylinders and arms until grease
starts oozing from ends of the bearings. The lubrication diagram on the
PERIODIC
MAINTENANCE CHECKLIST SHEET
shows where to fi nd the lube fi ttings. Wipe off
excess grease with a clean lint-free cloth.