1
1921 Slauson
A
ve. Santa Fe Springs, CA. 90670 (800) 227-41
16 F
AX (888) 771-7713
54
STEP 11 - ADJUST PLATFORM (IF REQUIRED)
- Continued
WELD TO VEHICLE FRAME AND MAIN FRAME
(RH SIDE SHOWN)
FIG. 54-1
15.
Clamp the RH side and
LH side mounting plates
to vehicle frame. Weld
the mounting plates to
vehicle frame as shown
in
FIG. 54-1
. Remove
clamps.
17.
Lower the
fl
oor jack and move it
away from the Liftgate.
CAUTION
Prevent damaged hydraulic hoses. Before welding next to hydraulic hoses,
protect the hoses with a heat-resistant cover.
CAUTION
To protect the original paint system, a 3” wide area of paint must be removed
from all sides of the weld area before welding.
16.
Reconnect power to the pump
by reconnecting positive
(+)
and
negative
(-)
cables to battery
(FIG. 54-2)
. Reinstall and tighten
nut when each battery cable is
reconnected.
RECONNECTING POWER
FIG. 54-2
POSITIVE (+)
BATTERY POST
NEGATIVE (-)
BATTERY CABLE
NEGATIVE (-)
BATTERY POST
NUT
POSITIVE (+)
BATTERY CABLE
1/4”
MOUNTING
PLATE
2” LG. 4 PLACES
(TYPICAL - RH & LH
MOUNTING PLATES)
MAIN FRAME
(CUT-AWAY VIEW)
VEHICLE FRAME
(TYPICAL TRUCK
FRAME SHOWN)
CAUTION
When using an electric welder, connect the welder ground to one of the parts
being welded, as close to the weld as possible. Failure to comply could result
in damage to cylinders and electrical parts.
Summary of Contents for GPTLR-25
Page 90: ......
