Maximum Controls MAX 1500, Quick Install Manual

Page: 15 / 28

MOTOR
ON-LINE
LIMIT
SWITCH
ON-LINE
24V GND
UL ALARM 12V
ALARM RET
RESET
GND
GATE
TAMPER
MAG
LOCK
OPEN
RIGHT
OPEN
LEFT
MAGLOCK
DELAY
PRIMARY
GATE
SAFETY CENTER EXIT
OPEN
MAX
GATE SPEED
STOP CLOSE
ANTI
TAILGATE
CLOSE TIMER
POSITION
RECORDER
ID
PLUG
AUTOMATIC OPEN/CLOSE CONTROLS
BATTERY
BACK-UP MODE
MATRIX 1
PHOTOCELL
EDGE 1
EDGE 2
ID PLUG
ERROR
OPEN
COM
CLOSE
Tamper NO
COM
GND
Tamper IN
OFF
OFF ON
EXIT
PARTIAL
OPEN
OBD PORT
BLACK BOX
MOTOR MOTION
CENTER
REVERSE SENSITIVITY
MOTOR OVERLOAD
NO LIMIT SWITCH /
CLAMP SLIPPING
MIN
MAX
12VDC
GND
24VDC
GND
MAX
MIN
OFF
SAFETY
LEAVE
OPEN
LEAVE
CLOSED
MADE in USA
OPEN
1 TIME
2Sec 1.5Sec
COM
NC
BATTERY
IN USE
POWER
GATE
STATUS
(+) GND (-)
PRIMARY
GATE
(+) GND (-)
SEC
GATE
UL
ENTRAP
PHOTOCELL GND STRIKE GND KEYP
AD / RDR
GND FIRE DEPT GND MAX OPEN GND RADIO SIG. RADIO GND OPEN STOP CLOSE COM GA
TE DISABLE
Gate
Tamper
Relay
The GATE TAMPER is factory set to OFF (Unarmed). See previous page for more information about ARMING GATE TAMPER .
If an existing alarm system (Building alarm system) is connected to the GATE TAMPER relay (see previous page), notify proper
authorities BEFORE dropping the chain.
IMPROPER Dropping of Chain (Vandalize):
Gate Shut-Off switch is NOT turned ON .
When the chain is improperly dropped (Vandalized), the OPERATOR ALARM and GATE TAMPER relay will activate. The operator will shut
down all operating functions.
The alarm reset button
MUST be pressed to turn OFF the alarm and reset the operator. If GATE TAMPER relay is connected to an existing
building alarm system, then they will get a triggering of their alarm system and should be notified of the situation.
PROPER Dropping of Chain while GATE TAMPER is ARMED:
1.
Turn Gate Shut-Off switch ON to disable operator alarm.
2.
Drop the Chain.
3.
GATE TAMPER relay WILL be activated.
4.
Service operator.
5.
Reconnect the chain to gate.
6.
Turn Gate Shut-Off switch OFF .
7.
Rearm an alarm system that may be connected to the GATE TAMPER relay.
ON
OFF
Gate
Shut-Off
ON
OFF
Gate
Shut-Off
Dropping the Chain - GATE TAMPER is ARMED (ON)
Gate Shut-Off Switch
Alarm Reset Button
13
UL 325 2016 Standard-MAX Quick Install Rev 8