Maxi Comet Executive Exec-56-G, Instruction Manual

Page: 132 / 244

Repair Comet Executive Gas
7-24
CAUTION
Tighten chain so the machine
runs smoothly. Too much
tension will cause a jerking
motion and can
damage bearings.
7. Turn the idler arm base (Figure 7-22, D) to
apply adequate tension to the chain.
8. Tighten the mounting bolt to hold the
adjustment.
9. Close and secure the right endframe door.
Ironing Cylinder Reconditioning
The following procedure gives instructions
for removing dirt, rust, alkali deposits, and other
similar contaminants from the fine polished
ironing cylinder surface. No chemicals can be
used to clean the ironing cylinder. Mechanical
cleaning, described below, must be done very
carefully. Important: Contact the Factory
Service Department before attempting to clean
a chrome ironing cylinder
.
CAUTION
For units with a chrome
ironing cylinder: Do NOT
attempt mechanical cleaning
of the ironing cylinder. The
chrome surface will
be damaged.
Do NOT use any cleaning or
polishing products unless
specifically instructed to do
so by the Factory Service
Department.
WARNING
To avoid the possibility
of severe injury, clean the
ironing cylinder only when
the unit is off (with the power
disconnected) and cool. All
cleaning should be done at
the rear of the unit.
Never attempt to clean the
cylinder while it is moving.
Serious Injury Could Result.
TOC INDEX