Copyright 2015 by Maxford USA
Page
14
RUMPLER TAUBE / Doc. Nbr. S160113
F.
RADIO-CONTROL SYSTEM
Connect and position your receiver at the rear of the battery compartment. Use the 5-volt power
supply built into the ESC to power the receiver and servos. (NOTE: A conservative modeler may use
a receiver battery or a switching UBEC to power the receiver and servos.)
G.
STICK-ON MARKINGS & WING WIRES
1.
Peel and stick the Iron Cross markings to the tops of the wing panels and to both sides of the twin
rudders as pictured below.
2.
Locate the 3 pieces of the top-side wing wire attachment structure
pictured at the right.
3.
Assemble and test-fit the structure to the openings in the fuselage
between the cockpits as shown below.
4.
Use glue to permanently mount the
structure between the cockpits.
5.
Attach the preinstalled simulated top-side wing wires to
the predrilled hole at the top of the structure as pictured
at the left.
Top-side wing wires and swivels
attached with 2 springs, 2 swivels
1 bolt and 1 nut.