MaxFlight FS-3000, Manual

Page: 14 / 131

14
2-1C Vertical Lift System
The hydraulic lift system is powered by a self-contained hydraulic power pack, located right
inside lower A-frame. Motor is 1.5 HP single phase 115/220VAC. Lowering solenoid is located on top
of pump pack. This solenoid is powered by the battery backup system power. This allows lowering the
unit to egress passengers without building power.
2-2 System Startup Procedures
The procedures listed below must be followed to ensure the simulator operates in a safe condition.
1. Turn on power to the battery backup, lower rear right “A” frame by pressing in power
button till unit beeps and NORMAL stays on.
2. Turn A-frame power ON, on side of operator station place finger through hole and
press the power button on the power strip.
3. Open curtain on left side, press power ON button on motion computer.
4. Turn ON the operator station monitor power. Push the power button if not already on.
5. Turn ON the cockpit projector by pointing the remote to middle bottom of projector,
press power button once, look on screen and verify projector comes on.
6. Go to rear of the on-board computer and press the RED button once, verify fans are
running.
7. Use remote and turn TV power ON.
8. Right click on red “M” G2E motion icon on desktop, select OPEN and allow window
to open fully.
a. Down/Lowered sensor light on green
b. Demo sensor light may be on
c. Brake Release sensor light is ON green
d. Top left inverter lights should be flashing red
e. Canopy open sensor light on RED
f. E-stop may be ON red if shoulder restraints are up.
g. Information window should show yellow with Instructions.
9. Pull out the red E-stop button below monitor. Turns ON the 3 phase power. The
inverter lights on top of the program should now be flashing GREEN.
10. Minimize the program window by clicking on (-) icon top right of window. The
program red “M” will show on task bar lower right. This program must always be
open to get motion on simulator.
11. Right click on red “C” command icon on desktop, select OPEN and allow to open
fully. Motion computer will query on-board computer for ride information and fill in
top row windows.
12. Click on the VIDEO MOTION icon top row
13. Select a coaster track RIGHT SIDE by clicking on any, coaster selected will show at
left side of screen, words will go dim until fully loaded, then comes back on in dark
letters
14. TV should show a coaster video with words MAXFLIGHT when program is ready.