MAXA N-P35A2, User& Installer'S Manual

Page: 22 / 34

21
■ REMOTE CONTROLLER
◊ Introduction of function buttons on the remote controller
①
ON/OFF key to turn the air conditioner on and off.
②
MODE key to select the operating mode: AUTO - COOL- DRY - FAN - HEAT:
③, ④
ADJUSTING (-/+) keys to adjust ambient temperature and the timer: " + " increasing, " - "
decreasing.
⑤
FAN key to set the fan speed in the sequence that goes from Auto, Low ( ), Low-Medium
speed ( ), Medium speed ( ), Medium-High speed ( ), High speed ( ).
Auto
⑥
SWING key used to set swing angle.
⑦
HEALTH / SAVE key to set HEALTH function for air cleaning.
⑧
key used to start or stop left & right swing function.
Note: This function is not available for this unit.
⑨
X-FAN key press it to begin/stop indoor fan which is used to dry the components.
⑩
TEMP key, press it to show the set point temperature on the unit’s display.
⑪
TIMER selection buttons. Press it to set auto-off/auto-on timer.
⑫
TURBO key used to enable/disable the rapid cooling or heating mode.
⑬
SLEEP key to set/cancel the Sleep mode regardless of the operating mode of the conditioner.
⑭
LIGHT key used to turn on or off the unit’s display.
FAN AUTO
OPER
HEALTH
AIR
FILTER
TURBO
ON/OFF
X-FAN
HOUR
HUMIDITY
ON/OFF
MODE
FAN
X-FAN
TURBO
TEMP TIMER
SLEEP LIGHT
2
11
7
10
13
9
4 3
12
8
6
14
5
1
◊
Name and functions of the display indicators
: AUTO mode indicator
: COOL mode indicator
: DRY mode indicator
: FAN mode indicator
: HEAT mode indicator
: SLEEP mode indicator
: TIMER ON-OFF mode indicator
: TEMP indicator
: LIGHT mode indicator
: LOCK indicator
: Air deflector indicator
: Signal sent confirmation LED
FAN : Fan Speed indicator
: Temperature display indicator
: Left & right swing icon is displayed when pressing the left & right swing button.
Press this button again to clear the display.
DISPLAY
FAN AUTO
OPER
HEALTH
AIR
FILTER
TURBO
ON/OFF
X-FAN
HOUR
HUMIDITY
◊
How to insert the batteries
Use two new alkaline type batteries with AAA 1,5V.
(1) Slide down the cover of the battery compartment.
Remove the used batteries and insert new ones correctly.
(2) Reattach the cover by sliding it back into its position.
Notes
♦ Do not use old batteries or different type batteries. Such a use may cause remote control
wrong functioning.
♦ If you do not use the remote control more than two weeks, remove the batteries.
Damages may be caused by possible leakages.
♦ Replace batteries when no "beep" is received from the indoor unit or if the transmission
indicator on the remote controller fails to light.