MAXA N-P35A2, User& Installer'S Manual

Page: 23 / 34

22
◊
How to use the remote control to operate the unit
● SWITCHING THE UNIT ON AND OFF
Press the key to switch the unit on or off.
● SETTING THE OPERATING MODE
By pressing the Mode key several times it is possible to change the unit operating mode. The selected operating
mode symbol appears on the display.
→ → → →
: automatic mode
: cooling mode
: dehumidification mode
: fan only mode
: heating mode
When the automatic programme AUTO is selected, the unit may operate in COOLING or HEATING mode depending
on the temperature difference in place between the ambient temperature and the temperature selected on the remote
control. When the cooling mode is selected, the unit operates with a free temperature setting, lowering the ambient
temperature. When the dehumidification mode is selected, the unit operates with a free temperature setting,
progressively lowering the ambient temperature and humidity. When the dehumidification mode is in operation, the
FAN button cannot be used. When the heating mode is selected, the unit operates with a free temperature setting,
raising the ambient temperature. When the fan mode is selected, the unit operates without temperature settings,
simply blowing air through the environment
.
IMPORTANT!
♦ The unit fan stops when the set temperature is reached and is then automatically reactivated at minimum
speed to prevent air stratification phenomena in the vicinity of the appliance.
♦ When the COOLING, DEHUMIDIFICATION mode is selected, the fan may not start up straight away
because the ANTI-HEATING mode is present. When the HEATING mode is selected, the fan may not start
up straight away because the ANTI-COOLING mode is present.
● SETTING THE FAN
By pressing the FAN key several times it is possible to adjust the fan speed between the three available speeds, or to
activate the AUTO mode. The operating mode appears on the display:
Auto
Auto, Low ( ), Low-Medium speed ( ), Medium speed ( ), Medium-High speed ( ), High speed ( ).
● SETTING THE LOUVER
In order to obtain optimal air distribution, adjust the motorised louver, making sure that the air flow is not directly
pointed at anyone. For the motorised louver, proceed as follows:
By pressing the key it is possible to select swing angle, which circularly changes as below.
OFF
Note: This remoter is universal. If any command , or is sent out, the unit will carry out the command as .
This symbol indicates the guide louver swings as:
● HEALTH | SAVE
Press HEALTH part of this button to turn on or off HEALTH function.
Pressing SAVE part of this button SE is displayed and the unit goes into SAVE operation mode. Press SAVE part of
the button again to cancel SAVE function. During SAVE operation, the temperature and fan speed is not adjustable.
Note: This function is not available for this unit.
● Function
♦ Press button to start or stop left & right swing function. The remote controller defaults to simple swing condition.
(This function is not applicable for some models).