MAXA i-2V514T, Manual

Page: 40 / 41

i-32V5
Pompe di calore inverter aria/acqua con ventilatori assiali
40
Register Format Bit R/W Range Name Description Note
954 BIT MASK
0
R - Alarms ⁴ ⁵
Module 2 probe 11 error E713
1 Link inverter 1 E801
2 Link inverter 2 E802
3 Link inverter 3 E803
4 Hardware fault inverter 1 E851
5 Hardware fault inverter 2 E852
6 Hardware fault inverter 3 E853
7 Overcurrent inverter 1 E861
8 Overcurrent inverter 2 E862
9 Overcurrent inverter 3 E863
10 High temperature inverter 1 E871
11 High temperature inverter 2 E872
12 High temperature inverter 3 E873
13 Bad voltage inverter 1 E881
14 Bad voltage inverter 2 E882
15 Bad voltage inverter 3 E883
955 BIT MASK
0
R - Alarms ⁴ ⁵
Phase sequence inverter 1 E891
1 Phase sequence inverter 2 E892
2 Phase sequence inverter 3 E893
3 Model error inverter 1 E901
4 Model error inverter 2 E902
5 Model error inverter 3 E903
6 Overload error inverter 1 E911
7 Overload error inverter 2 E912
8 Overload error inverter 3 E913
9 Overcurrent PFC inverter 1 E921
10 Overcurrent PFC inverter 2 E922
11 Overcurrent PFC inverter 3 E923
12 Internal communication error inverter 1 E931
13 Internal communication error inverter 2 E932
14 Internal communication error inverter 3 E933
15 Fault PFC inverter 1 E941
956 BIT MASK
0
R - Alarms ⁴ ⁵
Fault PFC inverter 2 E942
1 Fault PFC inverter 3 E943
2 Probe error inverter 1 E951
3 Probe error inverter 2 E952
4 Probe error inverter 3 E953
5 Abnormal condition inverter 1 E961
6 Abnormal condition inverter 2 E962
7 Abnormal condition inverter 3 E963
8 Inverter 1 EEPROM error E971
9 Inverter 2 EEPROM error E972
10 Inverter 3 EEPROM error E973
11 High discharge temperature of Cp3 E029
12 Anti-legionella performed correctly E060
13 Anti-legionella failed or stopped E061
¹⁾ if enabled
²⁾ the cycle is activated only if the DHW (4-5-6) status is terminated by the machine.
³⁾ if the read value is equal to 32766 the probe is not configured, if 32767 the probe is faulty.
⁴⁾ reset alarms, write the value 0 with the command 6 on any of the registers of the alarms area.
⁵⁾ the alarms of circuit 2 are mapped in the same way with an offset of 20000 (e.g. 20950).