12
ENGLISH
3. FITTING/REMOVING THE COMPUTER
3.1
Slide the computer onto the mount from the front until it
locks into place with an audible click.
3.2
To remove the computer, press the button underneath the
mount and slide
the computer out
towards the front of
the bike.
4. INSTALLING THE SENSOR NUT
4. Installing the Sensor nut
The speed sensor in this computer is integrated into a fixing
nut compatible with all quick-
releases on the market.
To install it, unscrew the fixing
nut on your quick-release.
Insert the quick release from the
left-hand side of your bike and
tighten the electronic fixing nut
from the right-hand side.
Adjust the tightness of the nut
so that the quick-release locking
lever can be sufficiently firmly
pushed into the CLOSE position
(if in doubt, consult your retailer
or the hub manual).
4.1 Road bike.
Once sufficiently tightened,
position the sensor
towards the
rear
before closing the quick-
release hub.
4.2 Mountain bike.
Once sufficiently tightened,
position the sensor
towards the
top
before closing the quick-
release hub.
6. INSTALLING THE BATTERIES
Power supply for the computer: 1 CR2032 battery.
Power supply for the speed sensor: 1 CR2032 battery.
Only use this type of battery.
Installing the batteries:
6.1
Remove the battery cover by turning
it a quarter turn anticlockwise, using
a coin.
6.2
Insert the battery into its recess,
keeping the + side uppermost.
6.3
Refit the battery cover and close it by turning
it a quarter turn clockwise.
Do
not to use excessive force
, or you will
damage the unit.
Check the condition of the seal on the battery
cover each time you change the battery. Replace
the battery cover if the seal is damaged.
Always perform the above operations in a dry
place.
1
2
5.3
6.2
6.1
4
5.1
4.1
5.2
5. INSTALLING THE MAGNET
5.1
Position the magnet on a spoke so that it passes
opposite
either of the lever marks and at a maximum distance of
5 mm.
When used on a mountain bike, it might be necessary to use
the adjustment magnets to reduce the distance between the
sensor and the magnet.
(5.2).
The magnet must be facing outward from the wheel.
5.3
Must be cut for use on profiled Zicral spokes
4.2
3.1
3.2
8. FUNCTION
8.1
To scroll dis
Screen 1:
• Spot speed
• Number of bik
• Pedaling cade
• Trip distance
Changing the c
effect of zeroing
total distance, m
(M or KM), whe
After installatio
batteries
(in sensors or
imperative to r
described in se
Battery life: 12
7. DESCRIPT
wintech-esbolt bis.indb 12
wintech-esbolt bis.indb 12
20/03/07 12:34:17
20/03/07 12:34:17
Cyan quadriMagenta quadriJaune quadriNoir quadri
