BLADE
1-6
TI215G0010
General information
Improper use
Improper use is the use of the machine outside the limits
specified in the technical documents.
Applicability
The regulations should be applied when carrying out
one of the following activities:
– Transport, Installation and Setting up;
– Manual Mode;
– Continuous Mode;
– Decommissioning and dismantling;
– Maintenance and repair that compose the use
procedures envisaged for the machine.
Installation and setting up
The installation and setting up of the machine are
permitted only by the authorized staff.
During installation, handle the machine components
as recommended in this manual. Should lifting be
necessary, verify first the correct fixture of devices
specifically for lifting and use adequate slings and
equipment. The machine installation area should be as
free as possible from any material that could prevent
or limit it from being seen. Check that all the machine
safety devices are correctly fixed and that no moving
or loose parts are present. Also check the soundness
of the components of the control unit. Connect the
pneumatic machine to the air distribution network
and carefully verify that the pressure value is correctly
set. Verify the consistency between the voltage set
on power transformers and the voltage value of the
energy distribution net. Before connecting the machine
electrical system, check that the sectioning device
of the power supply be blocked in the open position.
Verify that the anti-accident guards have been correctly
installed and are in good working order.
F
The machine safety is not guaranteed in case
of removal, by-pass or tampering of safety
devices on the machine.
To stop the machine in an emergency, press on the
emergency stop button.
Operating the machine
Only authorized and duly trained staff or at least with
a sufficient technical experience should operate the
machine. The staff in charge of the operating the system
should be aware that the knowledge and application
of safety regulations is an integral part of their job. Any
non-qualified staff should not access the operating
area and the machine control panel when the system
is running. Before starting the machine, carry out the
following operations:
– carefully read the technical documents;
– collect information on the operation and the position
of emergency stop devices on the machine;
– know which guards and safety devices are on the
machine, their position and their operation.
It is forbidden to either disconnect or partially remove
the guards and the safety devices. The same regulation
applies to the danger signals in particular areas of the
machine. It is strictly forbidden to access the working
area and the control and power cabins during operation,
even partial, of the equipment or immediately after it is
turned off.
guards and safety devices should be kept in perfect
condition so as to allow for their correction function¬ing.
In the event of failure, they should be immediately
repaired or replaced.
The unauthorized use of commercial parts and
accessories for the guards and safety devices can lead to
malfunctioning and the risk of dangerous situations for
the operating staff.
Decommissioning and dismantlign
Only authorized staff is allowed to decommission and
remove the machine.
– Before decommissioning, it is necessary to disconnect
the sectioning device power supply and to block it in
the open position;
– discharge oils and fluids, remove all moving parts;
– disconnect the power supply cable from the
sectioning device by cutting off the power wires first
and then the ground one;
– disconnect the power supply cable from the machine
main switch and remove it;
– disconnect the machine pneumatic equipment from
the air distribution network;
– remove the machine from the working area while
applying all regulations given in this manual;
– before lifting, verify the correct use of lifting devices
and use only suitable equipment.
Waste disposal should be performed in compliance
with the laws in force in the Country where the machine
has been installed. Installation, setting up and use of
compressor should be carried out in compliance with
the standards and the rules in force concerning safety
at work.
The owner of the machine is responsible for its good
maintenance, an essential condition to ensure operation
in total safety. Those machine parts that, due to improper
use, wear and tear, do not guarantee the safe operation
should be timely replaced. Only duly trained authorized
and qualified staff should perform the installation,
use, maintenance, and repairs. In case of discrepancies
